Description
Protect your electronics with this **Waterproof Plastic Enclosure Box**, designed to shield components from dust, moisture, and harsh outdoor conditions. Made from durable, high-quality plastic, it’s ideal for DIY projects, electrical installations, IoT devices, security systems, and industrial applications. Its sturdy construction and weather-resistant design ensure reliable performance in both indoor and outdoor environments.
Related products
-
This solar panel is rated at 9V and 2 Watts. At approximately 220mA, this solar panel has plenty of current for mid-sized projects. The panel’s exterior is covered with a durable plastic layer, and a sturdy PCB material backs it. Large solder-able pads on the panel’s rear side make for easy connections!
₵120.00 -
This turbidity sensor module is a specialized electronic monitoring device engineered for compatibility with various microcontroller platforms, including Arduino, Raspberry Pi, PIC, ARM, and AVR.
The Arduino Turbidity Sensor is a highly effective tool for assessing and verifying water quality through the measurement of turbidity. This sensor provides results via both digital and analog signals, which can be obtained through the designated pins on the accompanying electronic module. This functionality allows for accurate monitoring of water clarity, making it an essential instrument in various environmental applications.
₵145.00 -
This approach is highly advantageous for the development of prototype electronic devices. It enhances the visual appeal of your hardware project, providing a more polished and professional look in comparison to traditional single-sided perforated circuit boards.
₵15.00 -
Independent soil moisture sensor with built-in buzzer that gives a warning when the humidity is low.
The sensor distinguishes itself from other soil moisture sensors by the capacitive measurement instead of a resistance measurement. This makes the sensor a lot more corrosion-resistant and therefore lasts longer.
Specifications:
- Input voltage: 3VDC via a CR2032 button-cell battery (Note: the battery is not included, but is sold separately)
- Size: 140x15mm
₵50.00 -
Solar panels are a clean and ecological source of electricity. Obtaining this energy, however, poses several challenges for device designers. The amount of energy produced by the panel is strongly dependent on the angle of incidence and the intensity of the light falling on the surface of the cells. This, in turn, leads to unstable power supply parameters at the output, as even shading a small part of the panel may drastically reduce the efficiency
The optimal solution to the above-mentioned problems is the use of a set consisting of a solar panel, a battery and a charge controller. Such a set allows to ensure constant parameters of power supply to receivers and also to store energy produced excessively for later use
The SCC-30A-PWM-LCD solar charge controller allows you to connect panels both in series and in parallel – remembering not to exceed the permissible values of current and voltage at the input of the device. Due to the operating characteristics of the PWM controllers, it should be remembered that when the panels are connected in series, the rated voltage at the output for charging the battery is 24V.
₵210.00 -
₵10.00
Reviews
There are no reviews yet.