Description
- Size: 58 × 63 × 16 mm
- Cells: 4 AA
This battery holder features two 6″, 24-gauge leads that have approximately 5 mm of insulation stripped off of the ends. The red wire connects to the positive end of the batteries and the black wire connects to the negative end of the batteries.
Related products
-
This solar panel is rated at 9V and 2 Watts. At approximately 220mA, this solar panel has plenty of current for mid-sized projects. The panel’s exterior is covered with a durable plastic layer, and a sturdy PCB material backs it. Large solder-able pads on the panel’s rear side make for easy connections!
₵120.00 -
This BMS balance board is designed for a lithium battery pack to equalize voltage and protect the cells. This module monitors and protects the charging and discharging processes of the cells, balances them, and serves as a low-voltage and over-charge cut-off.
Original price was: ₵95.00.₵85.00Current price is: ₵85.00. -
The Nema 17 stepper motor boasts a compact and robust design, with an end face size measuring 1.7 inches by 1.7 inches. Known for its versatility, it is available in both single-shaft and dual-shaft configurations, making it suitable for a variety of applications. This motor operates with a precise step angle of 1.8°, translating to an impressive 200 steps per revolution, which allows for smooth and accurate movements.
Each phase of the NEMA 17 motor draws 1.2 A at 4 V, delivering a reliable holding torque of 3.2 kg-cm. This characteristic makes it ideal for demanding tasks where consistent positioning is essential. The Nema 17 stepper motor is widely utilized in numerous applications, including 3D printers, CNC machines, and laser cutters, where its precision and torque capabilities can significantly enhance performance and efficiency.
₵145.00 -
₵15.00 -
Solar panels are a clean and ecological source of electricity. Obtaining this energy, however, poses several challenges for device designers. The amount of energy produced by the panel is strongly dependent on the angle of incidence and the intensity of the light falling on the surface of the cells. This, in turn, leads to unstable power supply parameters at the output, as even shading a small part of the panel may drastically reduce the efficiency
The optimal solution to the above-mentioned problems is the use of a set consisting of a solar panel, a battery and a charge controller. Such a set allows to ensure constant parameters of power supply to receivers and also to store energy produced excessively for later use
The SCC-30A-PWM-LCD solar charge controller allows you to connect panels both in series and in parallel – remembering not to exceed the permissible values of current and voltage at the input of the device. Due to the operating characteristics of the PWM controllers, it should be remembered that when the panels are connected in series, the rated voltage at the output for charging the battery is 24V.
₵210.00 -
Power Bank Circuit with LCD Display Dual USB 5V 2.1A 1A module for creating a power bank for one Li-ion battery 1S (3.7 V) with LCD. It supports dual-USB technology, which allows you to connect two gadgets to USB ports at once and charge them at the same time.
₵100.00
Reviews
There are no reviews yet.